Muc-Off No Puncture Hassle Inner Tube Sealant 300ml

Instructions for use - for tubes with Schrader valve:
1. Remove the dust cover from the valve, bleed the air from the tyre and then spin the wheel so that the valve is between 9 o'clock and 12 o'clock.
2. Turn and pull the plastic tube out of the top of the bottle.
3. Detach the valve core removal tool from the top of the tube, then use it to remove the valve core from the valve stem (insert the two-pronged tool into the top of the Schrader valve and unscrew it counterclockwise to remove the core. Store the valve core well! )
4. Now place the end of the filling tube onto the valve stem and gently squeeze the bottle, bottom up, to get the desired amount of sealant into the valve. Ensure a smooth flow of sealant into the valve (fill the recommended amount of sealant into the filling tube using the dosing scale on the side of the bottle).
5. Remove the filler tube from the valve and wipe off any residual sealant.
6. Reinstall the valve core with the tool and tighten clockwise until tight.
7. Then inflate the tyre to the required pressure in accordance with your manufacturer's recommendations.
8. Spin your wheel and you're ready to go.
Instructions for use - for Presta valve tubes:
1. If you are filling sealant with NO PUNCTURE HASSLE inner tube into a Presta valve, you must first check that you have a removable valve core (not all Presta valve cores are removable). Do this by checking that the sides of the valve core have a flat edge. Presta valves with non-removable core will not have flat edges.
2. If it has flat edges, you can remove the core with the Presta valve core removal tool or a set of thin pliers by unscrewing counterclockwise until it is loose from the valve stem. Store the valve core carefully!
3. Now place the end of the filler tube on the valve stem and spin the wheel so that your valve is in the 6 o'clock position. Turn the bottle upside down and press gently on it to get the desired amount of sealant into the valve. Ensure a smooth flow of sealant into the valve (fill the recommended amount of sealant into the filling tube using the dosing scale on the side of the bottle).
4. Remove the filling tube from the valve and wipe off any residual sealant. Reinstall the valve core with the tool and tighten clockwise until tight.
5. Then inflate the tyre to the required pressure in accordance with your manufacturer's recommendations.
6. Spin your wheel and you're ready to go.
Volume:
300 ml
Temperature range:
-15 °C to 50 °C