INPRODUCTS Tent and backpack impregnation 200 ml

INPRODUCTS tent and backpack impregnation will protect not only your tent and backpack, but also your awning or umbrella from moisture and dirt. Whether the material is made of membrane, natural leather or synthetic fibers, the easy application of spray creates a thin film of silicon nanoparticles that repels water and dirt. This way, the fabric and leather will not get waterlogged, remain breathable, and you can prevent mould and sun damage. A thin film of silicon nanoparticles will prevent moisture and extend the life of your outdoor equipment by several years. The basis of the preparation is water. Thanks to this, the spray is colourless and odourless, not harmful to health and can be used safely even in confined spaces. INPRODUCTS impregnation for tents and backpacks prevents the growth of mould, which is harmful to equipment and health. With impregnation protectstextile membranes (Gore-Tex, Gelanot, SympaTex), natural leather, synthetic fibres (nylon, polyester), combination of the previous materials.

Silicon layer reliably protects against moisture

The impregnation for tents and backpacks creates a protective silicon layer on the fabric surface. It repels water and dirt, prevents the formation of unsightly stains and restores the water resistance of the outer tent shell. Thanks to the water-repellent layer, you don't have to wait for the fabric to dry. Simply shake off the drops. Intense UV radiation is not only dangerous for your health, but also damages the material of tents and backpacks. A protective layer of nanoparticles prevents sun damage to the fabric of the tent and backpack. As a result, your outdoor equipment will last much longer than with competing impregnations.
Expiration date:
Min. 2 years from date of manufacture
Volume:
200 ml
Consumption:
25 to 100 ml per 1 m² (depending on the absorption properties of the material)
Use:
Apply INPRODUCTS to clean, dry fabric. Shake the spray thoroughly before use. Apply the solution in a continuous layer from a distance of 10 to 20 cm. When applying to non-absorbent material, spread the solution over the fabric with a sponge. After application, wait 24 hours - during this time a protective silicon layer will form on the surface. During drying, place the treated object in a ventilated area.
Storage:
Store the solution container at temperatures between 3 and 30°C and out of direct sunlight.