Rust-Oleum Primer, 1 l, grey

This flexible sealing layer is designed for porous and unpainted mineral substrates. The single-component chlorinated rubber-based adhesion primer from Rust-Oleum ensures better adhesion of coatings on porous mineral surfaces. The contents are ready for immediate use – do not dilute. The reversible coating system allows the product to be dissolved in its own solvent. The coating is suitable for exterior use.

Preparation:
Clean and degrease the substrate. If the substrate is an acrylic paint, it MUST NOT be overcoated with Primer 44HS (the acrylic paint is affected by the solvents in Primer 44HS). In this case, use Pegafix instead of Primer 44HS. To ensure a uniform consistency, the product must be thoroughly mixed before application.
Application:
Apply in a dry and well-ventilated area.
Nozzle: 011–013
Pressure: 150–170 bar
Airless spray – do not dilute.
Clean tools and any spillages with Thinner 22.

Density:
1.1g/cm³
Solids by volume:
32%
Solids by weight:
45%
Drying at 20°C/50% RH:
Touch dry in 1 hour, handleable in 24 hours, recoatable after 24 hours, fully cured in 1 hour
Recommended wet film thickness:
70µm
Recommended dry film thickness:
23µm
Coverage:
Theoretical 14m²/L, practical 10–15m²/L
Flash point:
41°C
VOC safety data:
VOC of mixture as applied: 599g/L
VOC category: A/i
VOC limit: 750g/L
Measured value: 599g/L
Safety instructions:
Read the safety data sheet and the safety information on the packaging.
Storage:
Two years from date of production in unopened containers, if stored in dry, well-ventilated areas, at temperatures between 5°C and 35°C, and not exposed to direct sunlight.