Rust-Oleum Adhesion primer for smooth non-porous floors, white
Rust-Oleum Adhesion primer for smooth non-porous floors, white
Rust-Oleum Super Adhesion Primer for smooth, non-porous floors is a water-based epoxy primer for use on smooth floors such as concrete and paving. Super Adhesive 3333 should be used on non-porous, dense mineral substrates like tiles or power-trowelled concrete; non-ferrous metals such as stainless steel, aluminium or new hot-dip galvanised steel; and thermoset plastics, glass-fibre reinforced polyester or epoxy. It resists light to moderate abrasion, occasional high humidity, regular chemical cleaning, and chemical spills when topcoated with a suitable RUST-OLEUM system. It can be topcoated with virtually all RUST-OLEUM epoxy, polyurethane, vinyl and acrylic paints. Classified for surface spread of flame according to BS 476, Part 7: 1987, Class 1.
Key features of Rust-Oleum Super Adhesion Primer for smooth, non-porous floors, white
- Water-based epoxy primer
- Excellent adhesion to smooth and non-porous substrates
- Perfect chemical adhesion without the need for blasting or etching
- Low material consumption – real cost savings
- Can be topcoated with virtually any other 2K paint
- Water-based with a low odour
- Excellent flow
Surface preparation:
Remove grease, oil and all other surface contaminants with RUST-OLEUM FK 111 Cleaning Solution or by alkaline or high-pressure (steam) cleaning. New concrete should be fully cured and dry for at least 30 days before recoating.
The surface must be clean and can be slightly damp during application.
Instructions for use:
Stir the individual components thoroughly before mixing. Use a low-speed mixer.
Application conditions:
Air and product temperature between 10 and 35°C and relative humidity below 70%.
The substrate temperature must be at least 5°C above the dew point.
Application and thinning: brush:
Always dilute with 20% water by volume. Use brushes made from a blend of synthetic and natural fibres. Check the wet film thickness; avoid excessive film thickness. Preferably use disposable brushes.
Application and thinning:
Roller: Always dilute with 20% water by volume. Use an HD foam roller. Check the wet film thickness; avoid excessive film thickness. Preferably use disposable rollers.
Air spray: Dilute with up to 20% water by volume. Nozzle: 1.2–2.0mm. Pressure: 2–4 bar. Check the wet film thickness; avoid excessive film thickness.
Cleaning of tools and any spillage:
Immediately after application with (hot) water and soap.
Technical specification
Density: 1.58
Gloss level: Satin matt
Solids content by volume: 61.9%
Heat resistance: 150°C (dry heat)
Mixing ratio: Base : Activator = 0.72 : 0.28 (by volume)
Recommended wet film thickness: 25µm
Recommended dry film thickness: 15µm
Theoretical coverage: 41m²/L
Practical coverage: 25–30m²/L. Apply in a very thin coat, no more than 25µm wet film (15µm dry film).
Drying times at 20°C/50% RH:
Touch dry: 6 hours
Handleable: 8 hours
Recoatable: 16 hours (20°C), 24 hours (10°C), 12 hours (30°C)
Fully cured: 8 days
Pot life: 2 hours
Specifications
Usage
Technical parameters
Features
Packaging
Features
| Code: | RUSbar13 |
| Warranty: | 24 months |