MANIAC - neutral shampoo 1000ml for Car detailing

Use:
First phase - pre-wash with a foam gun: Dilute the product in the foam gun at a ratio of 1:10 (1 part product and 10 parts water). Spread the solution over the entire vehicle, always from the bottom up. Wait approximately 4 minutes for the product to start working and the foam to break down the dirt. Be careful not to let the foam dry on the bodywork. Always work in the shade and on a cool car body. Then proceed to rinse with a high-pressure washer from top to bottom. The easy rinse removes the foam quickly and without leaving any residue. After the pre-wash, you can proceed with a manual bucket wash with greater safety, as you have already removed approximately 80% of the dirt, especially the coarse particles that could cause damage to the paintwork on contact with the sponge or mitt.
Second phase - manual bucket wash: Add 3 caps of the product to a bucket with 10 litres of water. Neutral Foam Shampoo has an ultra-concentrated formula with a gloss effect and neutral pH. Use a second bucket with clean water to continuously rinse the mitt. Start from the top of the vehicle, always on a wet surface, and use a soft sponge or microfibre wash mitt. Work on smaller areas and apply as little pressure as possible. Let the product do the cleaning, not force. Rinse the mitt or sponge frequently in the bucket of clean water before moving on to the next panel. This will remove the coarse dirt trapped in the sponge, which could have an abrasive effect or cause scratches on the paintwork. Continue washing the entire vehicle, making sure the shampoo does not dry on the bodywork. After washing with the mitt or sponge, proceed with a thorough rinse and then dry with a Super Dryer ultra-absorbent microfibre cloth. It is recommended to use two Super Dryer cloths: one for the bodywork and the other for the windows to keep them as dry as possible. You can also use the cloth to finish profiles and fine details. When drying the sides of the vehicle or the lower parts, fold the cloth so that it does not touch the ground and pick up dirt that could cause scratches on the paintwork.
Recommendations:
To prevent the shampoo from drying out and causing stains, wash the car in the shade and never in direct sunlight.
If the vehicle has been exposed to the sun or the bonnet is very hot, cool the surface with a stream of cold water.
Start from the roof - it's the least dirty part, so you'll avoid soiling your mitt: washing will be quicker.
Try using two buckets - in the first, put the water and shampoo solution, in the second, just water to frequently rinse the sponge or mitt: this will prevent scratching the bodywork.
Wash in small sections - You won't miss any spots, the product will be able to work at its best without drying out: you will avoid spots and streaks.
Perfect circles - use a brush to clean the rims that can get into the most hidden places.