Reviews HECHT Electric Impact Drill 1200W HECHT 1077
Interested in reviews of HECHT Electric Impact Drill 1200W HECHT 1077? It got 3.6 out of 5 stars from our customers. Find specific customer reviews of HECHT Electric Impact Drill 1200W HECHT 1077 below. We will appreciate if you also share your experiences with HECHT Electric Impact Drill 1200W HECHT 1077 after purchasing.
HECHT Electric Impact Drill 1200W HECHT 1077
In stock 3 pcs
22,790 Ft
Add to Cart
Zdeněk, Jablůnka nad Bečvou
Rated 14/11/2026, variant HECHT Electric Impact Drill 1200W HECHT 1077
Verified purchase
I bought this for drilling without hammer action. I don't know if I was just unlucky with a bad unit, but the design for switching off the hammer action failed after drilling about 10 holes of 7mm diameter into 10mm sheet metal.
I needed to use the drill, so I decided to fix it myself, thinking it would be something minor. I took the drill apart (you also have to pull out the rotor - the brushes fall out and need to be lifted back up during reassembly) and found that the spindle shaft rests against a plate that is recessed too deeply. So even when "hammer action is off", the shaft already rests against the edge of the plate's recess, which had also worn down slightly. I modified the plate so it could be turned around and reinserted, and thought it was permanently fixed. The repair took about 1 hour. Over the next 5 hours or so, I drilled about 50 holes of 7mm diameter into 10mm thick sheet metal, and then the hammer action started kicking in again. The support plate had worn down again, even though the shaft was resting against the full surface of the plate. So I dismantled the drill for the second time, completely now, removed the chuck (the locking screw inside has a reverse thread, the main thread is right-handed), pressed out the bearings along with the hammer gear, and modified it using spacer rings (I inserted a ring with a 17mm hole and a thickness of approx. 3.5mm in front of the bearing) and adjusted the shaft seal so it wouldn't rub against the spacers. Now the axial force is supported directly by the main 6003 bearing behind the chuck, the hammer action is deactivated (which I don't need) and I believe it will work fine for drilling now. This modification is very complex and requires experience as well as proper equipment, otherwise it won't end well, plus you lose the warranty. As I wrote, if it worked, it would be great. However, I don't trust the hammer action control; I think the manufacturer got the design wrong. My modification took about 3 hours of my time. I have a smaller and cheaper drill from HECHT, which has handled far more and in worse conditions and still works, but this one disappointed me. I'm not saying this model is bad, but my unit definitely was. Next time, I'd send it back after the first fault.
The drill makes a decent first impression and if it actually worked, it would be great value for money, BUT
After 5min of drilling, the hammer action started kicking in even though it was switched off.
Quite noisy
The trigger has a stroke limiter dial, but even at the minimum setting, the speed is quite high. You can maintain a much lower speed using your finger.
0 ×Report
Automatic translation
Václav, Plzeň-Lhota
Rated 28/10/2025, variant HECHT Electric Impact Drill 1200W HECHT 1077
Verified purchase - review from a price comparison website
High-performance drill at an affordable price
0 ×Report
Automatic translation
Jiří, Praha
Rated 04/07/2025, variant HECHT Electric Impact Drill 1200W HECHT 1077
Verified purchase - review from a price comparison website
It's working as it should.
It's good for concrete
0 ×Report
Automatic translation