This compact USB 3.0 adapter with a case is designed for all 2.5" SATA SSDs and hard drives up to 9.5mm high.
It can handle all SATA, SATA II and SATA III 2.5" drives without limiting their maximum capacity.
The USB 3.0 interface guarantees seamless high-speed connectivity with all modern computers.
USB 3.0 • ANY 7 & 9.5 mm 2.5" HDD/SSD • ANY CAPACITY
The modern SATA III/6G interface with UASP support allows you to enjoy the speed of modern SSD drives to the fullest.
UASP support significantly increases transfer speeds especially when working with small files in the queue.
The external box also supports TRIM to reduce the gradual degradation of SSD performance over time.
SATA 6G • UASP • TRIM
Installing a drive now takes just a few moments.
Simply plug the drive directly into the SATA connector on the adapter and you're done.
The kit can be connected to a PC or inserted into the protective case for extra protection.
No screws, just a few simple steps.
THE FASTEST & EASIEST ASSEMBLY • SCREWLESS
The case holds a standard 2.5" drive with a USB adapter attached.
It also serves for transport or storage of the adapter itself without the drive, with the cable inside the case.
The product's modest dimensions and weight make it ideal even for occasional mobile use.
PRACTICAL CASE • MINI & LIGHTWEIGHT • MOBILE
Clean, minimalist design with a slim and lightweight body.
Pleasantly matte finish.
The bright blue LED indicates power and data transfer status.
PURE DESIGN • SLIM CASE • MATTE FINISH • DELICATE BLUE LED
Reads S.M.A.R.T. information monitoring the condition of an external disk.
Supports turning off the disk after you remove the device or put the PC in Sleep Mode.
You can boot your computer from an SSD or hard drive in an external box.
HDD SMART INFO • HDD TURN OFF • BOOT SUPPORT
AXAGON SLIMport 6 is a small, but very fast and handy tool that can be used in many ways, such as data storage and sharing, backup, disk testing, and more.
It is the ideal tool for data migration when replacing your laptop hard drive for a solid state drive.
In addition, the installation is so easy even a layman can do it - just connect the disk to the adapter and the adapter to the USB port of the computer. The rest is done automatically.
HANDY TOOL • DATA MIGRATION • AUTO INSTALL
Input interface:
1x USB 3.0
Device support:
Ports: 1x SATA 6G
Format: 2.5" HDD, SSD
Power supply:
via the USB bus
Properties:
Compatible with USB 3.0, backward compatible with USB 2.0.
Supports transfer speeds of 12/480/5000Mbit/sec (full / high / super speed).
Supports 2.5" SATA III / II / I disks of all capacities.
Compliant with Serial ATA 3.1 specification (SATA / 600), transmission speeds up to 6Gb/sec.
Compliant with Serial ATA 2.0 specification (SATA / 300), transfer rates up to 3Gb/sec (300MB/sec).
Compliant with Serial ATA 1.0 specification (SATA / 150), transmission speeds up to 1.5Gb/sec (150MB/sec).
The total bandwidth/bit rate of the adapter is determined by the USB 3.0 interface used (theoretically 5Gbit/sec).
UASP support (USB Attached SCSI Protocol) and BOT (Bulk-Only Transport).
Supports booting from an SSD/HDD drive connected via a USB adapter.
HDD Turn Off support - turns off the disk after removing the device or suspending the PC.
Hot Plug support - can be connected to a PC while in operation.
Full Plug and Play support.
Connection via USB 3.0 micro B female connector.
USB 3.0 cable USB 3.0 Type A male / USB 3.0 Type B male 10cm long is included.
Sufficient power supply via USB 3.0, up to 900mA from one USB port
A blue LED indicating the connection to the computer's USB port (permanent light) and data transmission (blinking).
More information:
Compact adapter dimensions 70 x 21 x 10mm, adapter weights only 11g, weight of USB cable 18g.
Simple plastic case holds 2.5" disk max. 9.5mm high with USB adapter connected (USB cable is led out through a hole in the case).
For thin 7mm SSDs/HDDs, foam pads are included for better fit in the case.
The case can also serve to transport or store the adapter itself without the disk, with the USB cable inside the case.
Case dimensions 122 x 78 x 19mm, weight 40g.
Supported operating systems:
MS Windows XP / Vista / 7 / 8 / 8.1 / 10 and later, Windows Server 2003 / 2008 / 2012 / 2016 and later (supports all 32- and 64-bit Windows OS versions), Mac OS X 10.x and higher, Linux with kernel 2.6.x and above.
Note: Drivers are included with supported operating systems and are installed completely automatically. No other drivers need to be installed and are not even available.
Package contains:
USB 3.0 - SATA adapter, USB 3.0 cable length 10cm, self-adhesive foam pads for 7mm HDD and SSD, plastic case.
Code: | AG200b02 |
Warranty: | 24 months |
Product Number: | ADSA-1S6 |
Links: | Producer's Website: |