K2 Adhesive for sticking rear view mirror 6 ml K2

Did your car's rear view mirror get stuck or broken off and you need to get it back in place? With this special adhesive, you can stick it on in no time. Thanks to the unique formula, the adhesive will harden quickly and the mirror will stick to the glass better than ever before. Of course, it can also be used with other materials.

Method of use

Mark the location of the old rear-view mirror on the outside of the window. Clean the glued surface mechanically from the old glue, e.g. with a razor blade. Pull off the paper sleeve and bend the plastic container to break the inner glass cylinder. The backing fluid spills out onto the felt tip. Apply a thin layer of primer to one of the bonded surfaces (e.g. a metal mirror holder that will be attached to the glass). Wait 1-2 minutes to dry. Carefully tear off the end of the plastic tube with the adhesive. Apply one drop or a thin layer of adhesive to a pre-cleaned surface. The adhesive is spread evenly when the metal holder is attached to the glass. Press the metal holder against the glass and hold for approximately 30 seconds. Be careful not to move the glued parts during gluing. Wait about 10 minutes before fitting the rear-view mirror.